JerryZ
2006-03-07 16:35:12 UTC
I'm relatively new to the higher end of audio/video products, but I
just jumped in with both feet... I bought a Sony KDS-R50XBR1 XSRD rear
projection TV and a Yamaha RX-V2600 receiver. While I am quite happy
with the sound, HDMI switching, and performance of my setup, I have a
problem that I can't seem to figure out. I can't get the OSD on the
receiver to work... I have a Comcast dual tuner HD-DVR hooked up via
component inputs, and I have 3 separate outputs to my tv, S-Video,
Component Video, and HDMI. I have tried setting the cable box to 480i
output as I understand that the OSD will only overlay at 480, that
didn't work. I have tried to get the display to work via component and
S-Video with no other input, still no OSD. I can't get to my advanced
settings if I can't see the OSD, and I don't understand enough about
how the receiver setup works to know why I can't get it to display.
Another (minor) issue may be that the remote that I have a slightly
different than the one showin in the manual for the receiver in that
when I am set to AMP on the remote, where the GUI Top button should be
is labeled Level, and there is an On Screen label above the Display
button. Any help that anyone can offer to me to figure this out would
bre greatly appreciated. Thanks!
just jumped in with both feet... I bought a Sony KDS-R50XBR1 XSRD rear
projection TV and a Yamaha RX-V2600 receiver. While I am quite happy
with the sound, HDMI switching, and performance of my setup, I have a
problem that I can't seem to figure out. I can't get the OSD on the
receiver to work... I have a Comcast dual tuner HD-DVR hooked up via
component inputs, and I have 3 separate outputs to my tv, S-Video,
Component Video, and HDMI. I have tried setting the cable box to 480i
output as I understand that the OSD will only overlay at 480, that
didn't work. I have tried to get the display to work via component and
S-Video with no other input, still no OSD. I can't get to my advanced
settings if I can't see the OSD, and I don't understand enough about
how the receiver setup works to know why I can't get it to display.
Another (minor) issue may be that the remote that I have a slightly
different than the one showin in the manual for the receiver in that
when I am set to AMP on the remote, where the GUI Top button should be
is labeled Level, and there is an On Screen label above the Display
button. Any help that anyone can offer to me to figure this out would
bre greatly appreciated. Thanks!